Tools & materials
- Screwdriver or drill
- Stud finder
- Toggle or self-drilling drywall anchors rated 25+ lb
- Spackle and putty knife
- Small level
Step by step
- Step 1
Loosen the set screw on the bottom of each post and lift the bar off its mounting brackets.
- Step 2
Unscrew the brackets and pull out the old anchors. Fill any torn holes with spackle if you'll be shifting position.
- Step 3
Check for a stud. If one lines up with a bracket, screw straight into it.
- Step 4
Where there's no stud, install a toggle or heavy-duty self-drilling anchor rated for at least 25 pounds.
- Step 5
Level the bar, screw the brackets back on firmly, then slide the posts on and tighten the set screws.
When to stop and call ProFix
If you see any of these, stop and call us:
- The wall behind is tile and you're not comfortable drilling it
- The drywall is soft or crumbling (possible moisture)
- The bar is part of a grab-bar safety setup (grab bars must hit studs or use rated anchors)
Not in the mood to DIY? A ProFix pro can handle it for you in Chicago Metro and Dallas–Fort Worth, with a written price before work starts.
Related guides
These guides are general information for simple repairs. You're responsible for your own safety and for following local codes and your lease or HOA rules. When in doubt, stop and call a licensed professional. All DIY guides